Devices

Purpose

The Devices Window is used to configure additional hardware and software options for the Station. Devices define the communication details for each peripheral attached to the Station. Keyboard wedge devices such as Card Readers and Scanners are not defined as devices in this context and should not be included.

Accessing the Devices Window

While in Focus Setup, select Locations > Stations > Devices.

Figure 7.28 Devices Window

Figure 7.30 Devices Window Fields

Field

Description

Device

Device	Description
Scanner	The Station will use a serial scanner. Note: Keyboard Wedge scanners do not need to be configured.
Scale	The Station will use a Scale for capturing the weight of an item from a Scale.
Pole Display	The Station will use a Pole Display.
Drawer	The Station will use a Cash Drawer. Note: Printers that emulate the Epson TM-88 will use the Access Code 1B70000A6 to open the drawer.
Changer	The Station will use a Coin Changer.
Caller ID	The Station will use a Caller ID system.
Fingerprint	The Station will use a Fingerprint scanner.
Berg	The Station will use the Berg interface.
Bar Vision	The Station will use the Bar Vision interface.
IP Log/Camera	The Station will use the IP Log/Camera interface.
Text Inserter	The Station will use a Text Inserter.
Order Confirmation	The Station will use an Order Confirmation board.
Pole Disp (ASCII)
Drawer 1 (Panasonic)

Port

The Port for the Device.

Baud

The Baud Rate for the Port.

Parity

The Parity of the Port.

Data Bits

The number of Data Bits for the Port.

Stop Bits

The number of Stop Bits for the Port.

Initialize

The hexadecimal codes that are sent to initialize the Device (i.e., pole display brightness).

Access

The hexadecimal codes that are sent to access the Device (i.e., open cash drawer). Note: Printers that emulate the Epson TM-88 will use the Access Code 1B70000A6 to open the drawer.

Figure 7.30.1 Pole Display Options Fields

Pole Display Options

Idle Messages	Two lines of 19 characters each to be displayed on the pole display. The Pole Display Idle Message will be displayed if an order has not been placed for 60 seconds.
Display Running Total	An updated subtotal will display on the pole display after each Menu Item is ordered.

Figure 7.30.2 Rear Display Fields

Field	Description
Format	The Rear Display Format the Station will use.
Width	The width (in pixels) for the Rear Display.
Height	The height (in pixels) for the Rear Display.

Job Right ‘Office - Stations’